8ft bullwhip

- Rachel McCollough
- Member of the Ring
- Posts: 9958
- Joined: Tue 21. Apr 2015, 11:37
- Location: South Mississippi, USA
- Contact:

- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40

- Craig Frank
- Member
- Posts: 1233
- Joined: Thu 23. Jul 2015, 21:06
- Location: Arizona


- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40

- Mark Elliott
- Member
- Posts: 4061
- Joined: Mon 11. Sep 2017, 20:28
- Location: Fritch, Texas US
- Contact:


- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40

- Robert Gage
- C Member
- Posts: 14188
- Joined: Fri 7. Feb 2014, 15:58
- Location: UK

-
Sir Roger Tuson

- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40

- Scott A. Cary
- Member
- Posts: 2398
- Joined: Sat 22. Jul 2017, 22:25

-
Sven van Leeuwen

- Brandon "Sparky" Lam
- Member
- Posts: 1314
- Joined: Thu 20. Oct 2016, 21:59
- Location: Melbourne, Australia

- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40


- Rachel McCollough
- Member of the Ring
- Posts: 9958
- Joined: Tue 21. Apr 2015, 11:37
- Location: South Mississippi, USA
- Contact:
Jyri, make you a copy of your paper pattern. Mark each one off as you do it. Plait and mark. Then, if you need to stop, clamp the side you have just plaited. Mark a dot on the next step. That's where you start next.... Do it the same every time and it will become a habit. You will soon not lose your place.
You are doing great, don't give up!!!
You are doing great, don't give up!!!
Inch by inch.

- Mark Elliott
- Member
- Posts: 4061
- Joined: Mon 11. Sep 2017, 20:28
- Location: Fritch, Texas US
- Contact:

- Scott A. Cary
- Member
- Posts: 2398
- Joined: Sat 22. Jul 2017, 22:25

- Jyri Haveri
- Member
- Posts: 2148
- Joined: Tue 28. Mar 2017, 12:40
Rachel i tryed that once and for some reason it was afully hard to find the right sequence on paper. I was always one line up or down even when i putted numbers on the lines
Best for me would be if i could print just the sequence from face plat. Like LEFT u6o4u1o2 etc

I habe been once again plaited and unplaited this little bit again and again.. I have changed my plans many times and i truly hope i get to finish this tonight.
Best for me would be if i could print just the sequence from face plat. Like LEFT u6o4u1o2 etc

I habe been once again plaited and unplaited this little bit again and again.. I have changed my plans many times and i truly hope i get to finish this tonight.





