Whip Basics. The Forum

I have some busted USB hubs that I could steal the actual plug from.

Ron - I will check for the USB - but i did expect a young guy like Brandon to make it wireless

I'm sorry, but the wireless functionality requires you to be within 2 metres of your computer for it to work ahahaha

On a more serious note, I'm very happy it arrived!! The 3D printed name I should have designed it to be a bit larger, the letters are a little mushed together XD But unfortunately this was back when I didn't have a good heel knot to accommodate the names at the end, finally worked out one though~

I'll definitely roll the whip a bit more, I've been doing it with a slightly wider board, but if I wanted to get some of the more annoying bits I'll start using a smaller edge to get more pressure! ^_^ Will experiment a bit more too, the strand additions do that when I pull tight, so I might have to loosen up my pull for just those bits XD

Thanks Morten, I hope you enjoy this whip!! The swap was quite fun, definitely want to do it again.

Thanks Ron and Rachel!!

Brandon you can tighten as normal and move those added/dropped strands with a fid just before you roll, done

Congratulations Morten and my compliments to your work Brandon !!!

All the best
Ben

Brandon - your handle pattern is really nice. Intricate without looking too busy. Overall it looks like a very well made whip. Congratulations!

Thanks Ben and Craig ^_^

Thanks for the suggestion, Rachel!~